Audio accessories

Amplifier rack for Apogee AE5 loudspeakers, with the original Apogee P500RV processor and digital amplifiers. It provides the separate amplification and processing needed by the AE5 system. This listing is for the rack only. AE5 speaker cabinets are rented individually and are not included. Tell us how many cabinets you want to use so we can confirm the suitable rack arrangement, connections and cabling for your system. The rack accepts 2 inputs and supports a maximum of 2 AE5 cabinets per output, with a maximum of 4 AE5 cabinets in total. This capacity applies only to the corresponding AE5 cabinets, not to a mix of loudspeaker models. Confirm the processing, amplifier channel allocation, connections and cabling for your system before use.

Amplifier rack for Apogee AE10 subwoofers, with the original Apogee P10RV processor and digital amplifiers. Use it as the amplification and processing section of an AE10 subwoofer system. This listing is for the rack only. AE10 subwoofer cabinets are rented individually and are not included. Tell us how many subs you want to use and which top cabinets will accompany them so we can confirm the suitable rack arrangement, connections and cabling. The rack accepts 2 inputs and supports a maximum of 2 AE10 cabinets per output, with a maximum of 4 AE10 cabinets in total. This capacity applies only to the corresponding AE10 cabinets, not to a mix of loudspeaker models. Confirm the processing, amplifier channel allocation, connections and cabling for your system before use.

Custom stagebox based on the Canford CSB3-12/12, with 12 male and 12 female XLR connectors. Fitted with one male and one female 37-pin Syntax multipin connector, using the owner-confirmed default LK37 pinout. The multipin connectors replace the fixed cable. Rental is per stagebox.

The Kenwood TK-3701D is a compact two-way radio for crew communication at events, productions and during setup and breakdown. It supports both digital dPMR446 and analogue PMR446 and can be used licence-free in the Netherlands. The European version has 48 channel memories across three zones and an RF output of 0.5 W ERP. Each rental includes one radio, a Kenwood KMC-45 speaker microphone, an acoustic-tube earpiece and a Kenwood KSC-35 charger. Radios must use the same frequency, operating mode and compatible tone or code settings to communicate. Select analogue mode when communicating with analogue PMR446 radios. Coverage depends on buildings, obstructions and the surroundings; a fixed range is not guaranteed. Protect the radio from water when audio accessories are connected.

The Radial J48 is a mono active DI box for connecting instruments to a mixing console or microphone preamp. It runs on 48 V phantom power and provides a 6.35 mm instrument input, a thru connection for an amplifier and a balanced XLR mic-level output. A -15 dB pad accommodates hotter signals, while the 80 Hz low-cut filter, polarity reverse and ground lift help adapt the signal to the setup. The Merge switch turns the input and thru sockets into two inputs summed to one mono output; it does not provide two independent DI channels.

Closed-back dynamic monitoring headphones in the 150-ohm HD660PRO version, with 40 mm neodymium drivers, velvet ear pads and a single-sided cable. Intended for studio, broadcast and monitoring use.

Connect a small wired event network with the TP-Link TL-SG105S. Its five Gigabit Ethernet ports provide a simple, unmanaged connection between compatible computers and network equipment without a configuration interface. The fanless metal enclosure suits a desk or technical position. Count every connection: a cable to your router or another switch uses one of the five ports, leaving four for local devices. This is a non-PoE switch, not a router or Wi-Fi access point; it does not provide internet access by itself.

Connect a small wired network for an event, control desk or temporary workspace with eight auto-negotiating Ethernet ports. The TL-SG108S is an unmanaged Gigabit switch in a compact, fanless metal housing: connect suitable Ethernet cables and external power, with no switch configuration required. One connection to a router or another switch uses one of the eight ports, leaving seven for local devices. This is a non-PoE switch, not a router or Wi-Fi access point; it does not increase your internet subscription speed. Check the network requirements of the actual equipment before use.